Count the seconds between a flash of lightning over the hills and its thunder: three seconds for every kilometer. Put your ear to a steel railing while a friend taps the far end, and the tap reaches you twice, first through the metal, then through the air. On a −25 °C night at Everest Base Camp sound crawls along at about 315 m/s; in a Nepalgunj afternoon at 40 °C it runs at about 355 m/s. Why does the medium matter so much, and why does the weather?
This unit answers that for mechanical waves, the waves that need a medium. It finds what sets their speed, works out the speed of sound in a gas the way Newton did, then shows where Newton went wrong and how Laplace put it right, and finally asks what changes the speed of sound in air: temperature, pressure or humidity.
7.1 Introduction
A mechanical wave is a disturbance that needs a material medium (a solid, a liquid or a gas) to travel through, carrying energy from place to place. A source disturbs the medium, and the energy is passed on by the vibration of the medium’s particles, each pushing on the next. Mechanical waves are of two types, longitudinal and transverse.
The previous unit described wave motion in general. This unit is about mechanical waves, sound above all: how they travel, what decides their speed, and how the conditions of the air change it.
7.2 Speed of mechanical wave
The speed of a mechanical wave is the distance the wave travels in unit time. In terms of its wavelength and frequency ,
The frequency is set by the source: a tuning fork marked 512 Hz makes the air vibrate 512 times a second, whatever the air. The speed is set by the medium. The wavelength then follows, . That is why a note keeps its pitch when it passes from air into water but its wavelength grows more than four times: the frequency stays, the speed changes.
Two properties of the medium decide the speed.
Elastic property. As a mechanical wave passes, each particle of the medium is pulled out of place and the medium is deformed for a moment. A medium that is elastic pulls the particle back, and that pull is what sets the next particle moving. The property that resists deformation and restores the medium is its elastic property, measured by its modulus of elasticity . The stiffer the medium, the harder each particle is pulled back, and the faster the disturbance is handed on.
Inertial property. To pass on the wave, each particle must be set moving, so it must have mass: the medium must store and carry kinetic energy. This is its inertial property, measured by the mass of a unit volume, its density . The denser the medium, the more sluggishly each part responds, and the slower the wave.
So the speed of a mechanical wave is
The elastic factor and the inertial factor take different forms for different media:
- A transverse wave on a stretched string. The restoring force is the tension , and the inertia is the mass per unit length :
- Sound (longitudinal) in a solid rod or wire. A rod is stretched and squeezed along its length, so the modulus is Young’s modulus of the rod’s material, and is its density:
- Sound (longitudinal) in a liquid or a gas. A fluid has no stiffness against stretching, only against being squeezed, so the modulus is its bulk modulus :
| Medium (about 20 °C) | Speed of sound |
|---|---|
| Air | 343 m/s |
| Water | about 1480 m/s |
| Granite | about 6000 m/s |
| Steel (a thin rod) | about 5100 m/s |
Steel is about 6500 times denser than air, but its Young’s modulus is over a million times larger than air’s bulk modulus (2 × 10¹¹ Pa against about 1.4 × 10⁵ Pa), so sound runs through it about 15 times faster.
A guitar string is tightened so its tension becomes four times as large. The speed of waves on it:
Pick an answer to see why.
7.3 Speed of sound in gaseous medium
Sound is usually made by something solid or liquid vibrating, a drum skin, a vocal cord, a bell, but it reaches our ears through the air. So the speed of sound in a gas is the speed that decides when we hear a sound. Working it out took two great scientists.
A sound wave is a pressure wave: as it passes, it makes compressions, where the air is squeezed to a slightly higher pressure, and rarefactions, where it is stretched to a slightly lower one. Squeezing a gas warms it and stretching it cools it, so the wave also changes the gas’s temperature a little, back and forth. The passage of sound through a gas is a thermodynamic process, and the question is which kind.
Newton’s formula
Newton assumed that sound travels slowly enough for any difference in temperature between compressions and rarefactions to even out: the gas stays at the same temperature throughout. The process is isothermal and obeys Boyle’s law. For a given mass of gas at pressure and volume ,
- Differentiating (7.1) by the product rule:
- Rearranging:
The minus sign appears because an increase of pressure () makes the volume smaller (); the bulk modulus itself is positive. So for an isothermal change, the bulk modulus of a gas equals its pressure, .
- The speed of sound in a gas is
so
This is Newton’s formula for the speed of sound in a gas. For air at STP, N/m² and kg/m³:
But the measured speed of sound in air at STP is about 331 m/s. Newton’s value is about 15% too low, far more than any error of measurement: something in his assumption was wrong.
Laplace’s correction
Laplace pointed out that a sound wave is fast. A compression and the next rarefaction are only half a wavelength apart and swap places hundreds of times a second, and air is a poor conductor of heat. So there is no time for heat to flow into or out of a compression or a rarefaction: the temperature rises in a compression and falls in a rarefaction. The process is adiabatic, not isothermal, and for a given mass of gas
where is the ratio of the gas’s principal specific heat capacities (the adiabatic index, or Laplace’s coefficient). It depends on the atomicity of the gas: about 1.67 for a monatomic gas such as helium, 1.40 for a diatomic gas such as nitrogen or oxygen.
- Differentiating (7.5):
- Dividing by :
So for an adiabatic change the bulk modulus is , larger than : the warmed air in a compression pushes back harder than it would at a steady temperature.
- With (7.7):
This is Laplace’s formula (Newton’s formula with Laplace’s correction). For air at STP, with :
very close to the measured value, about 331 m/s. Laplace’s assumption is the right one: sound in air is adiabatic.
Newton’s formula gives a speed of sound in air that is too low because he assumed that:
Pick an answer to see why.
7.4 Factors affecting the speed of sound in gas (air)
i. Temperature
The speed of sound in a gas is
- For one mole of an ideal gas, . The volume of one mole is its mass divided by its density, , where is the molar mass:
- Putting (7.10) into (7.9):
- For a given gas, , and are constant, so
If and are the speeds of sound in a gas at absolute temperatures and ,
The speed of sound in a gas is directly proportional to the square root of its absolute temperature. In warmer air the molecules move faster and pass the disturbance on faster. (The speed of sound is about 68% of the molecules’ root mean square speed, , in air.) So a graph of against absolute temperature is a straight line through the origin (Figure 7.3).
A handy rule near room temperature: the speed of sound in air rises by about 0.6 m/s for each degree Celsius, m/s with in °C. It comes from (7.12): m/s per kelvin. It is only an approximation; for large changes of temperature use (7.12).
Note: at the same temperature, the speed of sound is inversely proportional to the square root of the molar mass of the gas, (for gases with the same ). So sound travels faster in hydrogen ( g/mol) than in oxygen (32 g/mol) at the same temperature, four times as fast, since .
ii. Pressure
From (7.11), at a constant temperature is constant, and therefore
Then, from (7.9),
At constant temperature, the speed of sound in a gas does not depend on its pressure. When the pressure of a gas changes at constant temperature, its density changes in the same proportion (double the pressure, double the density), so stays the same, and so does the speed (Figure 7.4).
So the thin air at the top of Everest, at about a third of sea-level pressure, carries sound no slower for being thin. It does carry it slower because it is cold: at −30 °C (243 K), m/s.
iii. Humidity
Water vapor in the air is humidity. A water molecule ( g/mol) is lighter than the average molecule of dry air (29 g/mol), so moist air is less dense than dry air at the same temperature and pressure: . Since , sound travels a little faster in moist air than in dry air, and the more humid the air, the higher the speed.
The effect is small: at 20 °C, sound in fully saturated air is only about 0.4% faster than in dry air, a little over 1 m/s. Sound carries farther on some days and nights for a different reason: temperature. On a still night the ground cools the air near it, and the warmer air higher up bends sound waves back down towards the ground, so distant sounds, a temple bell, a far-off dog, are heard more clearly at night than in the heat of the day, when the warm air near the ground bends sound up and away.
A sound passes from cold morning air into warm afternoon air. Its speed and wavelength:
Pick an answer to see why.
A cylinder of air is compressed slowly to twice its pressure, its temperature kept the same. The speed of sound in it:
Pick an answer to see why.
Try all three factors at once:
Exercise
Choose the correct option
- Which of the following is correct about the speed of wave motion in a medium?
Pick an answer to see why.
- Which of the following factors affect the velocity of sound in air?
Pick an answer to see why.
- In which medium does sound travel fastest?
Pick an answer to see why.
- Which of the following expressions represents the velocity of sound in a gas?
Pick an answer to see why.
- What is the effect of rising temperature on the velocity of sound in air?
Pick an answer to see why.
- What does Laplace’s correction account for?
Pick an answer to see why.
- If the temperature of air increases, how does it affect the speed of sound?
Pick an answer to see why.
- A sound wave travels through a liquid at 1500 m/s. If the same wave travels through a solid of density 8000 kg/m³ and Young’s modulus 2 × 10¹¹ Pa, how does its speed compare?
Pick an answer to see why.
- What is the effect of humidity on the velocity of sound in air?
Pick an answer to see why.
- If the frequency of a sound wave is doubled, what happens to its wavelength in a given medium?
Pick an answer to see why.
- A student measures the speed of sound in air at 20 °C and finds it to be 343 m/s. What will the speed of sound be at 0 °C?
Pick an answer to see why.
- The frequency of a sound wave is doubled while the medium stays the same. What happens to its speed and wavelength?
Pick an answer to see why.
- A sonar signal is sent from a submarine and its echo from an enemy submarine returns after 4 s. If the speed of sound in seawater is 1500 m/s, how far away is the enemy submarine?
Pick an answer to see why.
- In a Kundt’s tube experiment, a metal rod vibrates in resonance and the wavelength measured in the air is 50 cm. If the speed of sound in air is 340 m/s and in the rod 5100 m/s, find the frequency of vibration.
Pick an answer to see why.
- The velocity of sound in hydrogen at 0 °C is 1250 m/s. What will it be in oxygen at 0 °C, given that the molar masses of hydrogen and oxygen are 2 g/mol and 32 g/mol?
Pick an answer to see why.
- A person shouts 150 m from a tall vertical cliff and hears the echo after 0.88 s. What is the approximate speed of sound in air?
Pick an answer to see why.
Answer these questions
- a.Discuss how the velocity of sound differs in solids, liquids and gases. Why does sound travel faster in solids than in gases?
- b.The bulk modulus of a liquid is 2.2 × 10⁹ N/m² and its density is 1000 kg/m³. Calculate the velocity of sound in the liquid.
Answer
- a.Derive the formula for the velocity of sound in a gas using Newton’s assumption. Then explain why Laplace’s correction was necessary.
- b.A gas has density 1.5 kg/m³ and bulk modulus 2.25 × 10⁵ N/m². Find the speed of sound in the gas.
Answer
- a.Describe Laplace’s correction to Newton’s formula for the velocity of sound in gases. How does considering adiabatic changes instead of isothermal ones correct the result?
- b.A gas has adiabatic index γ = 1.4 and molar mass 28.97 g/mol. Calculate the speed of sound in this gas at 300 K. (Use R = 8.314 J/(mol K).)
Answer
- a.Explain how temperature affects the velocity of sound in gases. Write the expression for velocity in terms of temperature and explain the physical meaning of each term.
- b.Calculate the speed of sound in air at 27 °C. (The velocity of sound in air at 0 °C is 331 m/s.)
Answer
- a.Explain the effect of pressure on the velocity of sound in a gas. Why is the velocity of sound independent of pressure under ideal conditions?
- b.Calculate the velocity of sound in a metal rod whose Young’s modulus is 2.0 × 10¹¹ N/m² and density 7800 kg/m³.
- c.The pressure of a gas is doubled while its temperature is kept constant. What will be the effect on the speed of sound? Justify your answer mathematically.
Answer
- a.How does humidity affect the speed of sound in air? Why does moist air allow sound to travel faster than dry air?
- b.The velocity of sound in dry air at 0 °C is 331 m/s. Calculate the velocity in air at 30 °C with 80% humidity. Assume the velocity increases by 0.1% for every 1% increase in relative humidity.
Answer
- a.How does molar mass affect the speed of sound in a gas?
- b.If the speed of sound in helium is 1005 m/s and in air is 343 m/s, compare the molar masses of helium and air using the velocity formula.
Answer
- a.How do the bulk modulus and the density of a medium affect the speed of sound? Explain for the different states of matter.
- b.At what temperature will the speed of sound in air be 350 m/s? Use the formula .
Answer
- a.A student says that an increase in atmospheric pressure increases the speed of sound in air. Do you agree or disagree? Justify with reasoning and equations.
- b.A tuning fork produces a sound wave of frequency 512 Hz in air. If the speed of sound is 344 m/s, calculate its wavelength.
Answer
Printable PDFs
- The unit as a book (A5) 12 pages Answers as an A4 booklet, 3 sheets
- Study notes 2 pages
- Worksheet 4 pages Answer key
- Harder practice questions 2 pages Answer key
Quiz yourself: Energy, Heat, Light and Sound, Grades 5–12 →
Practice every question in the book, and keep track of the ones you miss →
A companion to your textbook, not a replacement for it: study from the book your school uses, and where the two differ, follow your teacher. Found a mistake? Please tell us.
