Exam practice
Every question from the end of every unit, with hints and answers to open. After you check an answer, mark how you did, and come back to the ones you didn’t get.
11 questions
Unit 2 · Periodic Motion
Printable PDFs
- The unit as a book (A5) 18 pages Answers as an A4 booklet, 5 sheets
- Study notes 3 pages
- Worksheet 4 pages Answer key
- Harder practice questions 2 pages Answer key
Answer these questions
A body moves in simple harmonic motion along a straight line.
- a.Define simple harmonic motion. What are its essential characteristics?
- b.Derive the expression for the acceleration in SHM.
- c.A particle of mass 0.1 kg moves in SHM with a period of 2 s and an amplitude of 0.5 m.
- i.Find its total mechanical energy.
- ii.Find its kinetic energy when its displacement is 0.3 m.
- iii.At what displacement is its speed half its greatest value?
Answer
- a.Simple harmonic motion is a periodic motion in which the restoring force (and so the acceleration) is directly proportional to the displacement from the mean position and always directed towards it: , . Its characteristics: it is periodic, to and fro about a fixed mean position; the acceleration is proportional to the displacement and opposite to it; the speed is greatest at the mean position and zero at the extremes; the acceleration is zero at the mean position and greatest at the extremes; the period does not depend on the amplitude; and with no damping the total energy stays constant.
- b.Let the particle be the shadow, on a diameter, of a point going round a circle of radius with angular velocity ω. Its displacement is . Then , and . So the acceleration is : proportional to the displacement and towards the mean position.
- c. rad/s, m, kg.
- i. 0.123 J.
- ii. 0.079 J.
- iii. gives , so 0.433 m.
The figure shows a simple pendulum that swings back and forth between P and Q.
- a.It takes about 0.5 s to swing from P to Q. Estimate the length of the pendulum. (g = 9.8 m/s²)
- b.i. Draw a free-body diagram showing all the forces on the bob.
- ii.Use it to find the frequency of oscillation.
Hint
P to Q is half an oscillation.
Answer
- a.P to Q is half a period, so s. From , 0.25 m (24.8 cm).
- b.i. Two forces act on the bob: its weight , vertically down, and the tension in the string, along the string towards the point of suspension (as in Figure 2.6). Splitting the weight: along the string, balanced by the tension, and along the arc, towards the mean position: the restoring force.
- ii.The restoring force is for small angles, so , SHM with . Then 1.0 Hz, as it must be for a period of 1 s.
Consider a spring–mass system placed vertically.
- a.Define the equilibrium position in vertical SHM.
- b.How does the restoring force act in vertical SHM? Explain using Hooke’s law.
- c.A 5 kg block hung from a vertical spring stretches it by 0.25 m.
- i.Calculate the spring constant.
- ii.The block is pulled down further and set oscillating. Find its period. (g = 9.8 m/s²)
Answer
- a.The equilibrium position is the position where the mass hangs at rest, where the spring’s upward pull equals the weight: , being the stretch. The mass oscillates about this position.
- b.Displaced by below the equilibrium position, the spring is stretched by and pulls up with (Hooke’s law), while the weight pulls down with . The net force is : proportional to the displacement from the equilibrium position and directed back towards it. Above the equilibrium position, the spring’s pull is less than the weight, and the net force is downward, again .
- c.i. 196 N/m.
- ii. 1.00 s.
The diagram shows a mass hung from a helical spring, oscillating up and down. A motion sensor connected to a data logger records its motion.
- a.Name the type of oscillation shown.
- b.Write the expression for the period T of the vertical oscillation in terms of the mass m and the spring constant k.
- c.If the extension of the spring at equilibrium is h, derive a relation between h, g and T.
Answer
- a.Simple harmonic motion (a free oscillation of a spring–mass system; in practice lightly damped).
- b..
- c.At equilibrium the spring’s pull balances the weight: , so . Putting this in the period: , or . (The period is the same as a simple pendulum’s whose length equals the spring’s stretch.)
A torsion pendulum moves in angular SHM.
- a.What is angular simple harmonic motion? Give one example.
- b.Derive the expression for the period of angular SHM of a torsion pendulum.
- c.A disc of moment of inertia 0.05 kg m² hangs from a wire of torsional constant 0.10 N m/rad. Find the period of its angular oscillation.
Answer
- a.Angular SHM is an oscillation in which a body turns back and forth about an axis, under a restoring torque proportional to its angular displacement and opposite to it (), so that its angular acceleration is proportional to its angular displacement and towards the mean position. Example: a torsion pendulum (a disc hung on a wire), or the balance wheel of a watch.
- b.Turning the disc through θ twists the wire, which gives a restoring torque . With : , so . This is angular SHM with , so .
- c. 4.44 s.
A pendulum in air meets air resistance and slows down over time.
- a.What is damping in an oscillation? Name the types of damping.
- b.Explain what happens to the amplitude when the frequency of a periodic driving force matches the natural frequency of the system.
- c.A metal pendulum bob oscillates in still air. An investigator records its successive peak displacements on the same side of its equilibrium position, one period apart:
| Peak number | 1 | 2 | 3 | 4 |
|---|---|---|---|---|
| Displacement (cm) | 8.0 | 6.0 | 4.5 | 3.4 |
Assume the oscillations are small.
- i.Describe how you would sketch a displacement–time graph for this pendulum from these data. How does the graph show that the bob is damped?
- ii.If the undamped period of the pendulum is 1.6 s, will its actual period in air be exactly 1.6 s, slightly more, or slightly less? Give a reason.
- iii.The pendulum is now made to swing in thin oil instead of air. State two changes you would expect in the displacement–time graph.
Answer
- a.Damping is the loss of energy of an oscillating system to friction, air resistance or other resistive forces, which makes its amplitude die away. Types: light damping (underdamping: it oscillates, each swing smaller), critical damping (it returns to the mean position in the shortest time without oscillating) and heavy damping (overdamping: it creeps back slowly without oscillating).
- b.The system resonates: it takes in energy from the force most efficiently, and its amplitude grows to its greatest value, limited only by damping. With light damping this amplitude can be very large.
- c.i. Draw time across and displacement up, with the equilibrium position as the time axis. Draw a wave crossing the axis at equal intervals of time (half a period apart), its peaks on alternate sides, the first at 8.0 cm, the next on the same side, one period later, at 6.0 cm, then 4.5 cm and 3.4 cm, joined by a smooth wavy curve. The peaks lying on a falling curve (dashed through their tops) show the damping. Each peak is about 0.75 of the one before (6.0/8.0, 4.5/6.0, 3.4/4.5), so the amplitude falls by the same fraction each cycle: an exponential decay.
- ii.Slightly greater than 1.6 s. Damping opposes the motion and slows the bob down, so each oscillation takes a little longer than without it. In air the damping is light, so the increase is very small.
- iii.In oil the damping is much heavier: the peaks fall away much faster (each peak a much smaller fraction of the last), so there are far fewer oscillations before it stops; and the period becomes noticeably longer (the crossings of the axis further apart). In thick enough oil it would not oscillate at all.
A tuning fork vibrates under an outside periodic force.
- a.What is resonance? Under what condition does it occur?
- b.What is the phase relation between the displacement and the driving force at resonance?
- c.A forced oscillator has a natural (angular) frequency ω₀ = 5 rad/s. When it is driven by an outside force of angular frequency ω = 5 rad/s, its amplitude is greatest. Explain this with a graph, and state the resonance condition with numbers.
Answer
- a.Resonance is the large-amplitude oscillation of a system driven by a periodic force whose frequency equals the system’s natural frequency. It occurs when the driving frequency equals the natural frequency (, or ).
- b.At resonance the displacement lags the driving force by a quarter of a cycle, (90°). The velocity is then in step with the force, so the force always pushes the way the body moves and feeds in energy at the greatest rate.
- c.Sketch amplitude (up) against driving angular frequency ω (across), as in Figure 2.10: small at low ω, rising to a peak at ω = 5 rad/s, and falling again at higher ω; with lighter damping the peak is taller and sharper. The amplitude is greatest at 5 rad/s because that is the oscillator’s own natural frequency: each push then comes at the same point in each oscillation and adds to the motion, instead of sometimes opposing it. The resonance condition: rad/s, that is 0.80 Hz, a period of 1.26 s.
The graph shows how the amplitude of a system varies with the frequency of a periodic force applied to it. Points A, B and C are at the frequencies Fa, Fb and Fc.
- a.Name the physical phenomenon the graph shows.
- b.Identify the frequency Fb, and explain what happens to the amplitude at it.
- c.Compare the amplitudes at A and C, and explain why they are lower than at B.
Answer
- a.Resonance (the response of a forced oscillation).
- b.Fb is the natural frequency of the system (the resonant frequency). At it, the driving force is in step with the system’s own oscillation, so energy is fed in most efficiently and the amplitude is at its greatest, limited only by damping.
- c.At A (Fa, below the natural frequency) and at C (Fc, above it) the force is out of step with the system’s natural oscillation: for part of each cycle it pushes against the motion, so less energy is fed in and the amplitude is smaller than at B. As drawn, A and C are at about the same height, both well below B; far below the natural frequency the amplitude levels off at the force’s steady stretch, and far above it, it falls towards zero.
A block of mass m attached to a vertical spring moves in SHM.
- a.Define SHM, and derive its equation of motion using Hooke’s law.
- b.What is the total mechanical energy in SHM? Derive the expression, and discuss how the energy varies with time.
- c.Explain why the restoring force in vertical SHM does not depend on gravity.
- d.Two springs, of spring constants k₁ = 200 N/m and k₂ = 300 N/m, are connected in parallel to a mass of 2 kg.
- i.Find the effective spring constant.
- ii.Calculate the period of oscillation.
- iii.If the amplitude is 0.15 m, find the energy of the oscillation (the greatest energy stored in the springs).
Answer
- a.SHM is a periodic motion whose restoring force is proportional to the displacement from the mean position and directed towards it. For the block, at a displacement from equilibrium (where ), the net force is (Hooke’s law). Newton’s second law gives , or with : the equation of SHM, whose solution is .
- b.The total mechanical energy is the sum of its kinetic and potential energies (here, measured from the equilibrium position): (the work done against the restoring force , ) and . Total , the same at every instant. With time, the energy swaps between the two: all kinetic at the mean position, all potential at the extremes, twice each period; KE and PE each go up and down (as and ), while their sum stays constant.
- c.Gravity gives a constant force, . The spring’s stretch at equilibrium balances it once and for all; only the extra stretch gives an unbalanced force, . So gravity just moves the point of oscillation down by ; the restoring force about it, and the period , are the same as with no gravity.
- d.i. In parallel, 500 N/m.
- ii. 0.40 s (0.397 s).
- iii. 5.6 J (5.625 J).
A particle moves in SHM with an amplitude of 0.4 m and a frequency of 5 Hz, starting from the mean position.
- i.Find its angular frequency.
- ii.Find its displacement 0.1 s after it leaves the mean position.
- iii.Find its velocity and acceleration at that instant.
Answer
- i. 31.4 rad/s.
- ii. 0 m: half a period (0.1 s, since T = 0.2 s) has passed, so it is back at the mean position.
- iii. −12.6 m/s: the greatest speed, now moving the opposite way to its start. 0.
A system oscillates with a starting amplitude of 0.5 m. Because of damping, its amplitude falls by 5% each cycle.
- i.Find the amplitude after 10 oscillations.
- ii.If its starting energy is 40 J, how much energy is left after 10 oscillations?
Answer
- i.Each cycle leaves 95 % of the amplitude: 0.30 m.
- ii.Energy is proportional to the square of the amplitude, so each cycle leaves of the energy: 14.3 J.
