Exam practice
Every question from the end of every unit, with hints and answers to open. After you check an answer, mark how you did, and come back to the ones you didn’t get.
6 questions
Unit 22 · Capacitors
Printable PDFs
- The unit as a book (A5) 18 pages Answers as an A4 booklet, 5 sheets
- Study notes 3 pages
- Worksheet 5 pages Answer key
- Harder practice questions 2 pages Answer key
Answer these questions
The p.d. of a test circuit was measured as a capacitor was charged, and the graph below was plotted from the data.
- a.Explain what is meant by the term “capacitance”.
- b.Calculate the capacitance of the capacitor.
Hint
b. Read one point on the line, as far from the origin as you can.
Answer
- a.The capacitance of a capacitor is the charge stored on either plate per unit p.d. across it, . It is measured in farads (1 F = 1 C/V).
- b.The line passes through 660 µC at 3 V (and 220 µC at 1 V, 440 µC at 2 V):
(The slope of the Q–V line is the capacitance.)
In the figure below, a p.d. of 12 V is applied between P and Q.
- a.Calculate the charge on each capacitor.
- b.What single capacitor placed between P and Q would be equivalent to the two shown? Comment on your answer.
Answer
a. In parallel, each capacitor has the full 12 V across it.
22 µF: C = 264 µC.
47 µF: C = 564 µC.
b. 69 µF. Check: it would hold 69 × 12 = 828 µC = 264 + 564 µC. The equivalent capacitance of a parallel combination is larger than either capacitor: joining capacitors in parallel is like making the plate area bigger, so together they store more charge at the same p.d.
In the figure below, a p.d. of 12 V is applied between P and Q.
- a.What is the p.d. across each capacitor? Explain your answer.
- b.What single capacitor placed between P and Q would be equivalent to the two shown? Comment on your answer.
Answer
a. In series, both capacitors carry the same charge Q, so the p.d. across each is : the smaller capacitor has the larger p.d. Find Q first:
20 µF: 4 V; 10 µF: 8 V. Check: 4 + 8 = 12 V.
b. , so C = 6.7 µF (20/3 µF). The equivalent capacitance of capacitors in series is smaller than the smallest of them: it is like widening the gap between the plates, so the combination stores less charge at the same p.d. (80 µC, against 120 µC on the 10 µF capacitor alone at 12 V).
The figure below shows how the p.d. across a capacitor changes as it is charged.
- a.What is the capacitance of the capacitor?
- b.Calculate the energy stored in the capacitor when it has a charge of 100 µC, 200 µC and 500 µC.
- c.Sketch a graph of the energy stored against the charge.
Hint
a. The slope of this graph is V/Q, so C is its reciprocal. b. Use .
Answer
a. The line passes through 10 V at 470 µC:
b. , with F:
- 100 µC: J ≈ 0.11 mJ;
- 200 µC: J ≈ 0.43 mJ (4 times as much for twice the charge);
- 500 µC: J ≈ 2.7 mJ (25 times the energy at 100 µC).
(The same answers come from the area under the graph, : at 100 µC, V = 100 ÷ 47 = 2.13 V, and ½ × 100 µC × 2.13 V = 106 µJ.)
c. W ∝ Q², so the graph is a parabola through the origin, curving upward: flat at first, getting steeper.
A capacitor with a capacitance of 137 pF is charged until it stores a charge of 2.47 nC, and is then disconnected. It has a dielectric with a relative permittivity of 3.1. The dielectric is removed, so there is now a vacuum between the plates, but nothing else is changed. Calculate the change in the p.d. across the capacitor.
Hint
Disconnected, the charge can’t change. Removing the dielectric divides C by 3.1.
Answer
Before: V.
After: with a vacuum, pF. The charge is still 2.47 nC, so
(or simply ).
Change: the p.d. rises by 55.9 − 18.0 ≈ 38 V. Without the dielectric’s surface charges, the field between the plates is 3.1 times stronger, and so is the p.d. (Pulling the dielectric out takes work, which shows up as extra stored energy.)
An 8.0 µF capacitor is fully charged from a 12 V supply. Calculate the energy stored by the capacitor.
Answer
