Skip to content

← Fix It, in Practice

Bicycles · 28 of 58

Put the tube back without pinching it

Expert guidance

What you need

A pump, and tire levers only if you must.

Do this

  1. Pump the tube just enough to hold its shape, and lay it in the tire.
  2. Put the valve through its hole, pointing straight at the hub.
  3. Work the tire’s edges onto the rim by hand. Levers can pinch the tube.
  4. Look all round both sides. No tube should show.
  5. Pump a little and check again. The thin line on the tire should sit evenly above the rim.
  6. Pump to the pressure printed on the tire’s side. Soft tires pinch and flat again.
  7. Put the wheel back and test the brakes.

Why this way

A tube caught under the tire’s edge bursts, and a crooked valve tears later. A bulge means let the air out and reseat it. Expert guidance.

Do it today

Read the pressure on your tire’s side, and write it on a bit of tape on your pump. Three minutes.

Where these facts come from

General information. Switch off the power before touching anything electric, and leave wiring and gas to a trained person. You use it at your own risk: see our terms. Spotted a mistake, or know something better? Tell us.

← All 58 things to fix