Bicycles · 27 of 58
Patch a bicycle tube
Expert guidance
What you need
A patch kit with glue, patches and sandpaper, and a clean rag.
Do this
- Sand lightly around the hole. Grooves make a patch fail. Wipe it clean and let it dry.
- Spread a thin coat of glue, a little wider than the patch.
- Wait until it’s dry, several minutes. Test it at the edge, not the middle.
- Peel the patch, holding it by the edges, and center it on the hole.
- Press hard, especially round the edges, for over a minute.
- Check all the edges are stuck. Leave the clear film on.
- Don’t pump it up outside the tire. That stretches the patch.
Why this way
Glue-on patches bond with the rubber and last. Peel-and-stick patches are for emergencies, and that tube should be changed soon. A big hole or a torn valve can’t be patched, and a new tube is always the safest. Expert guidance.
Do it today
Open your patch kit. Is the glue still liquid? Buy a new kit if it’s dried up. Two minutes.
Where these facts come from
- How to Patch a Tire and Tube, Park Tool.
- Tire and Tube Removal and Installation, Park Tool.
General information. Switch off the power before touching anything electric, and leave wiring and gas to a trained person. You use it at your own risk: see our terms. Spotted a mistake, or know something better? Tell us.
