Bicycles · 24 of 58
Tighten a slack chain on a one-gear bicycle
Expert guidance
What you need
A wrench that fits the axle nuts, often 15 mm.
Do this
- Hold the bike steady. Touch only the outside of the chain.
- Halfway between the front and back teeth, push the chain up and down. It should move about 1.3 cm (half an inch).
- Too much? Loosen both back axle nuts a little.
- Pull the wheel back a little, keeping it centered between the frame’s arms.
- Tighten the nuts firmly, and check the movement again.
- Spin the wheel. Check the brake pads still meet the rim. Tug the wheel to be sure it can’t shift.
Why this way
Too slack and the chain can jump off. A loose wheel can come out as you ride, so the nuts must be properly tight. If unsure, have a shop check. Expert guidance.
Do it today
Do step 2 on your bicycle. Two minutes.
Where these facts come from
- Chain Replacement: Single Speed Bikes, Park Tool.
- Wheel Removal and Installation, Park Tool.
General information. Switch off the power before touching anything electric, and leave wiring and gas to a trained person. You use it at your own risk: see our terms. Spotted a mistake, or know something better? Tell us.
