Taps and water · 36 of 58
Stop a toilet that keeps running
Expert guidance
What you need
A screwdriver, and a new rubber seal if the old one is worn.
Do this
- Lift the lid and watch a flush. Cisterns differ, so learn yours first.
- Water at the top of the overflow pipe? Lower the float with its adjusting screw, until the water stops about 2 cm below the overflow.
- Float sunk? It’s leaking, and needs replacing.
- Chain tangled? Free it, leaving a little slack.
- Water seeping past the rubber seal at the bottom? Turn off the valve, flush to empty it, and fit a new seal. Take the old one to the hardware shop to match it.
- Turn the water on and test.
Why this way
A worn rubber seal is a common cause of silent leaks. Many toilets use a push-button unit instead of a chain. If yours doesn’t look like this, call a plumber. Expert guidance.
Do it today
Listen by the toilet when nobody’s used it. Hiss or trickle? Open the cistern and look. Five minutes.
Where these facts come from
- Toilet Troubleshooting, iFixit.
- Water emergencies: plumbing in your home, City of Edinburgh Council.
- Replace Your Leaky Toilet Flapper, US EPA WaterSense.
- Fix a Leak Week, US EPA WaterSense.
General information. Switch off the power before touching anything electric, and leave wiring and gas to a trained person. You use it at your own risk: see our terms. Spotted a mistake, or know something better? Tell us.
