Skip to content

← Grade 12 Chemistry

Exam practice

Every question from the end of every unit, with hints and answers to open. After you check an answer, mark how you did, and come back to the ones you didn’t get.

8 questions

Unit 11 · Phenol

Printable PDFs

Exercise 11.2

1.

Phenol is a hydroxyl derivative of benzene in which the –OH group is attached directly to a carbon of the benzene ring.

  • i.What are the IUPAC names of the compounds C₆H₄(OH)CH₃ with the structures in Figure 11.51?
  • ii.Compare the polarity of phenol and toluene.
  • iii.Draw the structural formulae of C₆H₄(OH)₂ and write their IUPAC names.
Hint

i. Carbon 1 carries the –OH; count to the methyl group.

Answer
  • i.I is 2-methylphenol (o-cresol); II is 4-methylphenol (p-cresol).
  • ii.Phenol is more polar. Its C–O and O–H bonds are strongly polar (oxygen is far more electronegative than carbon and hydrogen), and its dipole moment is about 1.2 D. Toluene has only C–C and C–H bonds, nearly non-polar; its dipole moment is about 0.4 D.
  • iii.Three isomers, Figure 11.4: benzene-1,2-diol (catechol), benzene-1,3-diol (resorcinol) and benzene-1,4-diol (quinol, hydroquinone).
2.

Phenol, also known as carbolic acid, is a white crystalline aromatic compound.

  • i.Compare the solubility of phenol and benzene in water.
  • ii.The boiling point of phenol is higher than those of benzene and toluene. Explain.
  • iii.Arrange in increasing order of boiling point: benzene, toluene, phenol and cresol.
  • iv.Give the reason for the lower boiling point and solubility of o-nitrophenol compared with the m- and p-isomers.
Answer
  • i.Phenol is moderately soluble (about 8 g per 100 mL), because its –OH forms hydrogen bonds with water molecules. Benzene is almost insoluble (under 0.2 g per 100 mL): it has no group that can hydrogen-bond, and the water molecules would have to break their hydrogen bonds to make room for it.
  • ii.Phenol molecules are held together by hydrogen bonds between their –OH groups. These must be broken to boil it. Benzene and toluene molecules are held only by weaker dispersion forces. Toluene’s molar mass (92 g/mol) is almost phenol’s (94 g/mol), yet it boils 70 °C lower: the difference is the hydrogen bonding.
  • iii.benzene (80 °C) < toluene (111 °C) < phenol (182 °C) < cresol (191–202 °C).

Cresol has the hydrogen bonding of phenol and a methyl group’s extra mass and dispersion forces.
iv. In o-nitrophenol, the –OH and –NO₂ groups are side by side and form a hydrogen bond inside the molecule (intramolecular, Figure 11.35). Its –OH is not free to hydrogen-bond to other molecules or to water. So less energy is needed to separate the molecules (lower boiling point, and it is steam-volatile), and it mixes less with water. In the m- and p-isomers the groups are too far apart for that: their –OH groups hydrogen-bond between molecules and with water (intermolecular), so they boil higher and dissolve better.

3.

Phenol is acidic: it releases H⁺ ions to produce the phenoxide ion.

  • i.The phenoxide ion is more stable than the ethoxide ion. Explain.
  • ii.Compare the acidic strength of phenol, ethanol and water.
  • iii.Discuss the effect of substituents on the acidic strength of phenols, and compare the acidic strength of the four phenols in Figure 11.52.
Hint

iii. Ask of each group: does it pull electrons out of the ring or push them in? Can it do so by resonance from where it is?

Answer
  • i.In the phenoxide ion the negative charge is spread by resonance over the oxygen and the ring carbons 2, 4 and 6 (Figure 11.16); a charge shared over several atoms is more stable. In the ethoxide ion, CH₃CH₂O⁻, there is no ring: the charge stays on one oxygen, and the ethyl group’s +I effect pushes more electron density onto it, making it less stable still.
  • ii.Ethanol < water < phenol (pKa 15.9, 15.7 and 10.0). Phenol is the strongest because its ion is stabilized by resonance; ethanol the weakest because the +I effect of the ethyl group destabilizes its ion. (Phenol is still weak: it turns blue litmus red only faintly, if at all, since a 0.1 M solution has a pH of about 5.5, inside litmus’s range of about 4.5–8.3.)
  • iii.Electron-withdrawing groups (–NO₂, –Cl, –CN) stabilize the phenoxide ion by spreading its charge further: they increase acidity, most strongly from the ortho and para positions, where they can act by resonance. Electron-releasing groups (–CH₃, –OCH₃, –NH₂) concentrate the charge: they decrease acidity.

Order: 4-methoxyphenol < phenol < 4-chlorophenol < 4-nitrophenol (pKa 10.21, 9.99, 9.41, 7.15).
4-methoxyphenol: the –OCH₃ group pushes electrons into the ring by resonance (+R), more than it pulls by −I, so it is slightly weaker than phenol. 4-chlorophenol: chlorine pulls electrons by −I more than it gives by +R, so it is slightly stronger. 4-nitrophenol: the nitro group pulls electrons by −I and takes the ring’s negative charge onto its oxygens by −R, so it is the strongest of the four.

4.

The hydroxyl group activates the benzene ring towards electrophilic substitution.

  • i.Give the reason for the ortho, para directing nature of the –OH group in phenol.
  • ii.Electrophilic substitution in phenol is faster than in benzene. Explain.
  • iii.With aqueous Br₂, phenol gives a trisubstituted product, but with Br₂ in CCl₄ or CS₂ it gives a monosubstituted product. Explain.
Answer
  • i.A lone pair of the oxygen is delocalized into the ring (+R). The resonance structures (Figure 11.32) put a negative charge on carbons 2, 4 and 6, so the electron density is highest at the ortho and para positions, and that is where the electrophile attacks. (The carbocation formed by attack there is also the most stable, since the oxygen can share its lone pair with the positive charge.)
  • ii.The same +R effect makes the whole ring richer in electrons than benzene’s (it far outweighs the −I effect of the electronegative oxygen). An electrophile seeks electrons, so it reacts with phenol’s ring faster.
  • iii.In water, a polar solvent, phenol partly ionizes to the phenoxide ion, which activates the ring even more strongly; water also polarizes the Br₂ molecule, making Br⁺-like attack easy. All three activated positions are substituted, and 2,4,6-tribromophenol precipitates. In CCl₄ or CS₂, non-polar solvents, phenol does not ionize and Br₂ is hardly polarized; at a low temperature the reaction is slower and stops after one substitution, giving 4-bromophenol (major) and 2-bromophenol.
5.

Complete the following sequence: phenol → (?) → benzene → (?) → ? → (?) → ?

The textbook prints only the first two compounds, so the sequence doesn’t work as a question with one answer; any correct route counts, and one natural way is shown here.

Hint

The first step removes the oxygen. Then think of a route that puts it back.

Answer

Figure 11.53: phenol is heated with zinc dust, giving benzene; benzene with concentrated H₂SO₄ gives benzenesulphonic acid; fused with NaOH it gives sodium phenoxide (which acid turns back into phenol):
CX6HX5OH+Zn→CX6HX6+ZnO \ce{C6H5OH + Zn -> C6H6 + ZnO}
CX6HX6+HX2SOX4→CX6HX5SOX3H+HX2O \ce{C6H6 + H2SO4 -> C6H5SO3H + H2O}
CX6HX5SOX3H+3 NaOH→CX6HX5ONa+NaX2SOX3+2 HX2O \ce{C6H5SO3H + 3NaOH -> C6H5ONa + Na2SO3 + 2H2O}
(Another correct route: benzene → nitrobenzene (conc. HNO₃/H₂SO₄) → aniline (Sn/HCl) → benzenediazonium chloride (NaNO₂/HCl, 0–5 °C), which warm water turns into phenol.)

6.

In phenol the –OH group is an electron-releasing group and activates the ring. How does an electron-withdrawing group at the meta position affect the reactivity of phenol towards electrophilic substitution?

Answer

It lowers the reactivity. A group such as –NO₂ pulls electrons out of the ring, so the ring is less rich in electrons than phenol’s and reacts more slowly with electrophiles (though usually still faster than nitrobenzene, since the –OH still activates it). The –OH group, the stronger director, still sends new groups to its own ortho and para positions. The same group makes the phenol more acidic, by pulling on the phenoxide’s charge (3-nitrophenol, pKa 8.36).

7.

Phenol undergoes bromination easily, whereas benzene needs a Lewis acid catalyst. Explain this in terms of electronic structure.

Answer

Benzene’s six π electrons are spread evenly and held fairly tightly. Bromine, Br₂, is not a strong enough electrophile to attack it, so a Lewis acid such as FeBr₃ is needed to polarize it into Br⁺ (as FeBr₄⁻). In phenol, a lone pair of the oxygen is fed into the ring (+R), raising the electron density, most of all at carbons 2, 4 and 6. This ring is so rich in electrons that it polarizes Br₂ itself and reacts without any catalyst, even at room temperature.

8.

Predict the major product when phenol is treated with:

  • i.dilute HNO₃
  • ii.concentrated HNO₃
  • iii.CH₃COCl in the presence of pyridine
Answer
  • i.A mixture of 2-nitrophenol (major) and 4-nitrophenol (Figure 11.34).
  • ii.2,4,6-trinitrophenol (picric acid), with concentrated H₂SO₄ (Figure 11.36).
  • iii.Phenyl ethanoate (phenyl acetate), CH₃COOC₆H₅, by O-acylation; pyridine takes up the HCl (Figure 11.28).