Taps and water · 34 of 58
Clean out the bend under the sink
Expert guidance
What you need
A bucket, rubber gloves, and a rag.
Do this
- Put the plug in. Tell everyone not to use the sink.
- Put on rubber gloves, and put the bucket under the bend.
- Unscrew the trap, or its small cleanout plug. Plastic ones usually undo by hand.
- Clear it out over the bucket with a stick or bit of wire. Most clogs are here.
- Screw it back with its rubber seal in place. Tighten by hand, or a little more with a padded wrench.
- Run hot soapy water through it, and watch for drips.
Stop if
Drain cleaner has gone in, or there may be needles or sharp things in the trap. Then leave it to a plumber. Same if the sink is still blocked: the block is further along.
Why this way
The bend keeps water in the pipe to stop drain smells, and it’s where food and soap collect. Expert guidance.
Do it today
Look under your kitchen sink and find the trap. Is it plastic, and does it have a cleanout plug? Two minutes.
Where these facts come from
- Making Simple Repairs: Clogged Drains, University of Florida Extension.
- Water emergencies: plumbing in your home, City of Edinburgh Council.
- What Every Renter Should Know About Plumbing Repairs, iFixit.
General information. Switch off the power before touching anything electric, and leave wiring and gas to a trained person. You use it at your own risk: see our terms. Spotted a mistake, or know something better? Tell us.
